RESUMO
A major bottleneck limiting the commercialization of aqueous zinc ion batteries (AZIBs) is dendrite formation on the zinc anode during the plating/stripping process, which leads to rapid performance and device failure. In this regard, researchers are trying to design more stable anodes toward suppressing dendrite formation. One possible solution to tackle this problem and to extend the cycling life of AZIBs is to modify the zinc anode surface by coating carbonaceous materials, enabling controlled charge flux and uniform ion distribution. This work reports a sustainable and bio-derived polylactic acid (PLA) as a coating layer on the zinc anode. Carbonizing this polymer under ambient conditions using a high-power nanosecond laser forms a carbon-coated zinc foil, which was directly utilized as the anode in aqueous zinc ion batteries. The fabricated laser-processed PLA-derived carbon-coated zinc anode demonstrated an extended cycling life of almost 1600 hours, significantly outperforming the bare zinc anode. A full aqueous zinc ion battery assembled from as-modified anode and as-prepared V2O5 nanofibers as cathode was able to deliver a specific capacity of 238 mAh g-1 at 1.0 A g-1 with a capacity retention of 70 % after 1000 cycles.
RESUMO
A Gram-negative, arsenite-resistant psychrotolerant bacterial strain, Yersinia sp. strain SOM-12D3, was isolated from a biofilm sample collected from a lake at Svalbard in the Arctic area. To our knowledge, this is the first study on the ability of acid-treated and untreated, non-living biomass of strain SOM-12D3 to absorb arsenic. We conducted batch experiments at pH 7, with an initial As(III) concentration of 6.5 ppm, at 30 °C with 80 min of contact time. The Langmuir isotherm model fitted the equilibrium data better than Freundlich, and the sorption kinetics of As(III) biosorption followed the pseudo-second-order rate equation well for both types of non-living biomass. The highest biosorption capacity of the acid-treated biomass obtained by the Langmuir model was 159 mg/g. Further, a high recovery efficiency of 96% for As(III) was achieved using 0.1 M HCl within four cycles, which indicated high adsorption/desorption. Fourier transformed infrared (FTIR) demonstrated the involvement of hydroxyl, amide, and amine groups in As(III) biosorption. Field emission scanning electron microscopy-energy dispersive analysis (FESEM-EDAX) indicated the different morphological changes occurring in the cell after acid treatment and arsenic biosorption. Our results highlight the potential of using acid-treated non-living biomass of the psychrotolerant bacterium, Yersinia sp. Strain SOM-12D3 as a new biosorbent to remove As(III) from contaminated waters.
